Housewives have their own set of home cleaning tricks. Now with the improvement of people's living standards, cooking machines have begun to enter the masses of households. The convenience and speed of use have brought a lot of convenience to the family, but the cleaning and maintenance have stumped the housewives. The cleaning of the knife head and the residue on the inner wall of the cup are all difficult to clean. However, don't worry. The editor will introduce several small methods for you today.
1. If it is mixing meat, it is a step that is more difficult to clean. There are often minced meat at the knife head which is difficult to clean. This requires skill. First, when mixing the meat, put more oil in it. It will reduce its stickiness. After stirring, use the remaining dried steamed bun slag to directly remove the residue attached to the head. 2. If it is dry grinding pepper aniseed, some fine powders are more difficult to handle. You need to clean it with a detergent first, then wipe it with a dry cloth, and finally it is best to use boiling water for scalding, so that it can be called in the gap of the knife head. The fines are fully dissolved, and the cleaned is relatively clean. 3. Cleaning of freshly squeezed juices. Fruits contain a lot of fiber, especially fruits such as mangoes and oranges. If they are stirred, they will block a lot of pulp at the knife head. You must be careful when cleaning. The clogged fiber strip can be slowly drawn out according to the direction in which it is wound. Don't use too much force. Others can be scrubbed with steel wire, but don't use too much force to avoid damage to the cutter head. 4. After each use of the juicer, it should be scalded with boiling water to avoid bacteria, which will affect the health of the family and the next use. How to use the juicer 1. Before use, check whether the props and filter of the juicer are installed firmly, and then install the cup firmly and confirm the food or fruit. Before squeezing the juice, it should be cut into pieces that fit the entrance of the juicer and put in the juicer. 2. Push the food into the cup, keep it at a constant speed, and avoid moving too fast or too hard to avoid danger. After the food is processed, unplug the power first, and then pour out the processed food. 3. Carefully clean the internal and external components of the juicer, but avoid water flow into the motor. Place the juicer in a ventilated place away from direct sunlight to completely dry it in the shade. Maintenance of the juicer 1. Before use, screw the cutter and the centrifugal filter tightly, then fasten the upper case where the centrifugal filter and cutter are placed on the base and cover the outer cover, and use the live fastener to fasten it. Boot function. Turn on the power again. 2. Put the fruit after the motor starts and runs normally, but the amount of fruit should not be too large to avoid damage to the knife edge. 3. When using, the juicer must be placed flat on the work surface and used in accordance with the correct operating requirements. 4. When squeezing juice, check the pomace tank frequently. If the juice pomace in the pomace tank is too full, immediately cut off the power supply and clean it before use. Otherwise it will cause the juicer to shake, cause the juicer to be damaged and be dangerous to yourself. 5. When the juicer is in use, do not open the lid of the cup, and do not put your hands or other utensils into the juice cup or the juice inlet when the power supply is not cut off, otherwise an accident or damage to the machine may occur. 6. In order to ensure the service life, the motor is equipped with an over-temperature protection device. When the motor runs for a long time or overloads, the power will be automatically disconnected when the temperature is high. After the motor stops working, the power cord must be unplugged and the motor must be cooled down. After hours, it can be used again. 7. The juicer must be thoroughly cleaned after use to prevent the growth of bacteria, but do not directly rinse it with water, otherwise it may cause an electric shock when it is used next time.